Pro/Forums - View Single Post

mrobsidian · 01-13-2003, 03:08 AM

The intake is a smooth 7/8" ID, 1" OD, hard plastic tube that sticks out about an inch. The exhaust is a 1/2" ID, 6/8" OD hard plastic tube that extends from the top about an inch and is not barbed. It tapers just a bit at the end (from the OD to the ID).

01-13-2003, 03:08 AM	#5
mrobsidian Cooling Neophyte Join Date: Jan 2003 Location: Atlanta, GA Posts: 3	Hydrothruster The intake is a smooth 7/8" ID, 1" OD, hard plastic tube that sticks out about an inch. The exhaust is a 1/2" ID, 6/8" OD hard plastic tube that extends from the top about an inch and is not barbed. It tapers just a bit at the end (from the OD to the ID).