I got done with the rest of the work on the lazer so I cut the acrylic peices.
I was very off on how long it would take to cut them out. This time I needed 3 peices of acrylic cut. One to sit on top of the base with the hole cut in it to allow water to flow, this peice is 1/8" and will be replaced later by just milling the 1/8" hole on the base which will end up being 1/4". The second peice is the peice with the shower head nozzel in the middle. I thought it would take 2 minutes to cut but I was wrong. It took 49 seconds, also 1/8".
The last peice is the top peice with just the holes for the barbs. It is 1/4" and took 39 seconds to cut out. All the peices have 6 holes for the screws to hold it all together aswell. Parts wise I got less than 20mins into it so far. All the peices are all cut out. Now I just need to drill and tap the holes in the base, tap the holes for the barbs, and seal it. The acrylic peices will be sealed with acrylic epoxy and the base to the acrylic will be clear silicone this time around. This one i will have to make some kind of mounting plate to mount it. The final design will probably have this in the base. I will try to get my damn cam hooked up tonight and show the peices I have done. I will start a new thread for this though and stop rambling here.