Pro/Forums - View Single Post

jaydee · 01-13-2003, 08:43 PM

Alright here we go. First off I am going to aplogize for the crappy pics. I had to use my cheap webcam as I still cannot get the good one to work.

Here is the top. 1/4" acrylic. It took 50 seconds on the lazer to make. I couldn't put the mounting holes in at work today as I didn't have time to re-lookup the deminsions so I will do that later if I decide to make this a working prototype. REV. 2.0 will use the base for the mounting instead of this top peice.

Here is the middle section with the nozzle cut into it. Will take some testing to figure out how many holes to use. These holes are 1/16" and the material is 1/8". This peice took 39 seconds on the lazer to make.

Here is the bottom peice. I needed to make this so I has a place for water to flow.

It is 1/8" thick and took 20secs to cut on the lazer. This peice will be replaced by the base in REV 2.0. As I will mill out the ovel.

And here is the base. Right now it has 1/16" pits drilled into it right over where the core will be on an XP AMD CPU. I have the nozzel aimed right at it and should help in the heat transfer. REV 2.0 will still have the same identical pattern but in copper. This will take a lot of testing to know if more pits will be needed/useful.

01-13-2003, 08:43 PM	#1
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	New Block REV. 1.0 (pics) Alright here we go. First off I am going to aplogize for the crappy pics. I had to use my cheap webcam as I still cannot get the good one to work. Here is the top. 1/4" acrylic. It took 50 seconds on the lazer to make. I couldn't put the mounting holes in at work today as I didn't have time to re-lookup the deminsions so I will do that later if I decide to make this a working prototype. REV. 2.0 will use the base for the mounting instead of this top peice. Here is the middle section with the nozzle cut into it. Will take some testing to figure out how many holes to use. These holes are 1/16" and the material is 1/8". This peice took 39 seconds on the lazer to make. Here is the bottom peice. I needed to make this so I has a place for water to flow. It is 1/8" thick and took 20secs to cut on the lazer. This peice will be replaced by the base in REV 2.0. As I will mill out the ovel. And here is the base. Right now it has 1/16" pits drilled into it right over where the core will be on an XP AMD CPU. I have the nozzel aimed right at it and should help in the heat transfer. REV 2.0 will still have the same identical pattern but in copper. This will take a lot of testing to know if more pits will be needed/useful.