I just checked something diode reading from tbred is totaly wrong on 8k3, I find it strange that my temps were imidiatly much higher even at default temp end frequency that, should not be with tbred B that runs much cooler then 0.18 palominos (my older cpu). So after I calculate compensation for cpu sensor in MBM using arctic silver instructions, I find out I need to substract 18°C from my readings, and then to test it I use halt command in wpcredit which basicaly shuts off cpu and my temps with compesation are where they should be few degrees above my water temps. Of course now I'm wondering if 2mm base won't be worse then 1mm. I need to check that as soon as I finish that block.
|