Quote:
Originally posted by morphling1
Ok correct me if I'm wrong, I need to cut the last L3 bridge, this will enable me 13-20x mp's, but in addition, if I solder 100 ohm resistor to AJ27 pin in socket A I get the ful range of multipliers.
If that's true I'm doing this tomorrow 
nicozeg thanks
|
Nono, that 100 ohm resistor does the same job as reconecting the bridge, so it's only needed in case U want to go back to the low range, or switch easily between both. there's no way to enable the full range at the same time if the mobo dont support it.
If I'd was you, I'll never go back to the low mp. At that fsb, without a /6 pci divider, I fear a short live to your HD. Sorry, but I had a traumatic data loss when running pci at 44 mhz.
