Quote:
Originally posted by Volenti
try designing a high performance water block, that can be made with "average" workshop tools, that doesn't end up resembling the WW in some way, believe me I tried, and I couldn't come up with one.
Visualise what is happening water flow wise in the pin area, focus in on a pin a couple of rows back from the jet impingment zone, look at the shadow area behind the pin, do you really think that you'll have a little bit of dead water just sitting there? having 0 interaction with the very fast flow of highly turbulent water streaming past 1mm either side of it?
|
No, you're right, but only because the pin's shadow isn't in a straight line with the inlet and flow direction.
You could try the same pin pattern, but made from 45 degree cuts.