Quote:
Originally posted by 8-Ball
jaydee, what are using (or planning to use) to seal between the acrylic layers?
8-ball
|
Acrylic cement like IPS Weld-On #16. REV 2.0 may not have the layers though. Probably just an acrylic top and copper base, but I havn't ruled out a 1/8" spacer with or without the nozzel. If I do not use the 1/8" spacer then I will just use a 1/2" thick base insted of the planned 1/4" one.
Quote:
Originally posted by 8-Ball
jaydee116, do you have the socket offset in there? .053something offset to one end
and lemme guess? the crappy way of trying to make a jet? do the 1 hole jet
|
REV 2 is going to be nothing like anything said/shown in this thread except it will be single inlet/dual outlets, with a drilled base. Thats about it. As for the jet I am undecided if it will be applied yet or not. If it is it will be of a one hole design. Possibly oval shaped. That will be in REV 2.1.
The base will look nearly identical the Cathars white water exept no micro channels, in place will be the drilled base. The offset may be included in the mounting. I have to measure it out later. It isn't very much. I need to order some copper stock. I have the 1/4" acrylic top already done but still need to do some thinking on the base sizes ect... Didn't have anytime this weekend as it is my daughters birthday so I spent the majority of it doing stuff with her. Always first on the priority list.