Thread: Dan from Danger Den recommended this site..very nice place:)
View Single Post
Unread 01-21-2003, 09:52 AM   #2
bigben2k
Responsible for 2%
of all the posts here.
 
bigben2k's Avatar
 
Join Date: May 2002
Location: Texas, U.S.A.
Posts: 8,302
Default
Welcome to ProCooling!


Personally, I would opt for sending the block to a machinist, to have a groove cut, but it is possible to remove the ATI shim.

IMO, I think it's best to leave the PC components intact, as much as possible.
bigben2k is offline   Reply With Quote