Pro/Forums - View Single Post

jaydee · 01-21-2003, 02:55 PM

Heheheheheh...

I made the base design today at work while I hade a few mins. I lied, it isn't going to be drilled. it has a pin array with PYRAMID shaped pins.

The base is 1/8" aluminum (because ofa lack of copper), and the pins hight is .030". The cuts where into to base so they go down .030" aswell. The cutter used had a V shaped tip so that is how the pyramid shaped pins came about. The pins are very small. At the bottom they are 1/16" wide and at the top 1/32".

Bst part is it only took 13mins to do. I will get a pic up one way or another tonight in a new thread called "REV 2.0. Micro PYRAMID Pins". I have to go cut out the spacer plate then get back to real work.

.

01-21-2003, 02:55 PM	#22
jaydee Put up or Shut Up Join Date: Dec 2001 Location: Spokane WA Posts: 6,506	Heheheheheh... I made the base design today at work while I hade a few mins. I lied, it isn't going to be drilled. it has a pin array with PYRAMID shaped pins. The base is 1/8" aluminum (because ofa lack of copper), and the pins hight is .030". The cuts where into to base so they go down .030" aswell. The cutter used had a V shaped tip so that is how the pyramid shaped pins came about. The pins are very small. At the bottom they are 1/16" wide and at the top 1/32". Bst part is it only took 13mins to do. I will get a pic up one way or another tonight in a new thread called "REV 2.0. Micro PYRAMID Pins". I have to go cut out the spacer plate then get back to real work. .