Quote:
Originally posted by N8
They used to be open for several hours on Saturdays. I don't know if they do that anymore though.
|
I didn't know that. I might have to check one of these weekends when I have time.
I found my 1/8" C110 copper stock this morning and just ran a base out with it. Still only took 15mins.
The bit is toast though. I am running another one out in AL with a narrower angle on it and going to shoot for .050 deep. I have to order some new bits here anyway. One's I got are well used.
The machine is a Xenetech XOT 1625 rotory engraver.
http://www.xenetech.com/html/1625.htm
I will probably not be able to use it in the future for this and will end up going back to the drilled holes in REV. 3.0. But while I have the chance I thought I would try it out. Then I can test against the drilled holes later.