I am planning on placing a water reservoir in the fridge I have. The reservoir will be connected to a copper coil located in the freezer section. Both of these will connect to copper tubing that has been epoxied into the holes drilled into the side wall of the dorm fridge. Outside, will be my mag drive 250 that I got for a whole $13 and change. The water block will be a custom Cu cross drilled water block. All tubing is .5" ID nylon reinforced vinyl tubing (not sure if it is vinyl, but it is reinforced.) How does this setup sound?
I would run the frion from the frig right thru comper tubing in your water tank pail what ever
i would think a 5 gel pail in the frig would work ok and have lots of balk to store cool if you use a coolent other than water you mite get it below 32 f
but watch out most coolents for cars get stiff wane thay get cold and thay are mad to work at 160for more new cars run 220 f i hear
any way with the motor hot
|