Pro/Forums - View Single Post

winewood · 02-10-2003, 03:53 PM

I am looking to add my new stuff in my case. Res, Pump, Rad, but I do not have room in the bottom, nor wish for the inaccessiblity to the water reservoir. SO, are there any reasons why I can not just stack these items to the top of the case, and tiewrap them down in a quasi-attractive fashion, then cut 2 holes for tubing going into the proc.?

I just want to avoid a n00b no no about something that was addressed before I jumped into the forums, and was already common knowledge. You helpful suggestions would be appreciated.

02-10-2003, 03:53 PM	#1
winewood Cooling Savant Join Date: Nov 2002 Location: in my chair Posts: 574	simple question on placement I am looking to add my new stuff in my case. Res, Pump, Rad, but I do not have room in the bottom, nor wish for the inaccessiblity to the water reservoir. SO, are there any reasons why I can not just stack these items to the top of the case, and tiewrap them down in a quasi-attractive fashion, then cut 2 holes for tubing going into the proc.? I just want to avoid a n00b no no about something that was addressed before I jumped into the forums, and was already common knowledge. You helpful suggestions would be appreciated. __________________ -winewood-