Pro/Forums - View Single Post

bobn4burton · 02-10-2003, 05:13 PM

I have posted this at hard forums...but I wanted to get your opinions... Been reading these forums...but this is my first post

We have come up with our preliminary design for our water block. We drew it up in a CAD program to get a good three dimensional view that can be directly imported into the mill.

We were just wanted to get some opinions on our design before we get it milled out. We will probably mill it in a week or so.

Here is a picture of the block:

The block is about 1/2" thick. The fins and walls separating the channels are 1mm thick. You can see the little 2mm divets on the bottom of the channels. The channel has a 11mm width.

Here is a sliced view of the block...so that you can see the base with the divets better:

Here is a pic of the top plate:

We made the block to fit both P4 and AMD XP chips.
So what do you guy's think?

02-10-2003, 05:13 PM	#1
bobn4burton Cooling Neophyte Join Date: Feb 2003 Location: Utah Posts: 11	New water block design...opinions?? I have posted this at hard forums...but I wanted to get your opinions... Been reading these forums...but this is my first post We have come up with our preliminary design for our water block. We drew it up in a CAD program to get a good three dimensional view that can be directly imported into the mill. We were just wanted to get some opinions on our design before we get it milled out. We will probably mill it in a week or so. Here is a picture of the block: The block is about 1/2" thick. The fins and walls separating the channels are 1mm thick. You can see the little 2mm divets on the bottom of the channels. The channel has a 11mm width. Here is a sliced view of the block...so that you can see the base with the divets better: Here is a pic of the top plate: We made the block to fit both P4 and AMD XP chips. So what do you guy's think?