Pro/Forums - View Single Post

starck · 02-13-2003, 09:38 AM

Thanks again for all the input

I've read about better not restricting the inlet of the pump, but then Im getting more confused about my setup.

I kinda prefer going for 1/2" ID tubes, but then again bcos I'll be using some Innovatek and Aqua-computer's parts, their fittings are like 6mm quick connect or a maximum of 10mm barbed.
Maybe I shouldnt get a the MD20rz?
Sorry for my ignorance, the setup Im running now is a Koolance, this is actually my first self built WC system

I have already bought the MCW50-T, two of them, for the GPU and the NB, and the block is able to take smallest 3/8"OD QC, or 1/2"ID tubes, pretty flexible, but the problem goes to the Rad, with G1/4" thread, and the reservoir, 1/8" thread.

So, shall I run my system like this :

Or shall I simply run everything with their default 6mm ID tubes

Thanks a lot! You guys are really helpful Ive already learned a lot by reading out the posts.

starck

02-13-2003, 09:38 AM	#8
starck Cooling Neophyte Join Date: Jan 2003 Location: HKG Posts: 12	Thanks again for all the input I've read about better not restricting the inlet of the pump, but then Im getting more confused about my setup. I kinda prefer going for 1/2" ID tubes, but then again bcos I'll be using some Innovatek and Aqua-computer's parts, their fittings are like 6mm quick connect or a maximum of 10mm barbed. Maybe I shouldnt get a the MD20rz? Sorry for my ignorance, the setup Im running now is a Koolance, this is actually my first self built WC system I have already bought the MCW50-T, two of them, for the GPU and the NB, and the block is able to take smallest 3/8"OD QC, or 1/2"ID tubes, pretty flexible, but the problem goes to the Rad, with G1/4" thread, and the reservoir, 1/8" thread. So, shall I run my system like this : Or shall I simply run everything with their default 6mm ID tubes Thanks a lot! You guys are really helpful Ive already learned a lot by reading out the posts. starck