Pro/Forums - View Single Post

starck · 02-13-2003, 11:20 AM

I read about that from some sites, forgotten where but I have it cut and pasted into my preparation notes.
I'm not really sure about this though

Here's the original version :
"I have yet heard is to sleeve the 10mm barb fittings (or use a reducer) and connect a balance pipe (by means of T-pieces or Y-connectors) to counteract any flow restriction induced by this"

Maybe I should do it like this,

pump outlet-->largest possible tube--->reducer--->10mm tube--->res.--->10mm tube--->rad--->10mm tube--->reducer--->1/2"ID--->pelt block--->1/2" ID--->pelt block 2--->largest possible tube--->pump inlet.

hows this sound?

Thanks a lot!!

starck

02-13-2003, 11:20 AM	#15
starck Cooling Neophyte Join Date: Jan 2003 Location: HKG Posts: 12	I read about that from some sites, forgotten where but I have it cut and pasted into my preparation notes. I'm not really sure about this though Here's the original version : "I have yet heard is to sleeve the 10mm barb fittings (or use a reducer) and connect a balance pipe (by means of T-pieces or Y-connectors) to counteract any flow restriction induced by this" Maybe I should do it like this, pump outlet-->largest possible tube--->reducer--->10mm tube--->res.--->10mm tube--->rad--->10mm tube--->reducer--->1/2"ID--->pelt block--->1/2" ID--->pelt block 2--->largest possible tube--->pump inlet. hows this sound? Thanks a lot!! starck