Well here is V2.1.....
And here are the latest renderings:
http://thengc.net/images/watercooled...eg-press/v2.1/
As you see we have color coded things once again to make the parts more visible. I will break down the pieces using this pic.
The bottom is the Blue piece. It will be either .25" or .375" thick (still debating). All the sides are clear in the pic and are not supporting any weight of the top. They are going to be 1/4" thick.
What will be supporting the weight are ten 3/4" Rods (pictured in yellow) that will be tapped on the top and botom. They will be screwed to the bottom piece and the top supports ( two 1/4" thick pieces stacked on top of eachother). They are the red/orange pieces. In between the top supports and the rods will be the top piece (except for the hatch door which is the clear piece on the top), it will be 1/8" thick, along with the hatch door. It is pictured in green. Underneath that piece will be several pieces that will make up our support for the hatch door. It is the black/grey piece. That is the piece where the hatch door will sit and the piece where we will afix the thumbscrews to button down the hatch. There will ne foam there to act as an air gasket.
Here is an updated parts list:
Pump: Iwaki MD-20RZ(T)
http://www.iwakipumps.com/pub/SpecSheets/MD1520.pdf
Radiators: Two Fedco 2-617 Heatercores
http://www.heatercore4u.com/2-617.htm [Purchased]
Custom reservoir with 1/2" NPT female threads for 5/8" Barbs
Quick Disconnects: 5/8" Nominal flow CPC Valved shutoffs
http://www.colder.com/fl_series.cfm [Purchased]
Waterblocks:
1 CPU Waterblock (
http://jpiperformance.com/water_blocks.htm )
1 GPU Waterblock (
http://www.dangerden.com/mall/chipset.asp )
1 NB Waterblock ( DD Danger Den Z-Chip Block )
Fans: Six 120X25mm Aluminum Fans
http://jab-tech.com/120mm_aluminum_a...ome_79cfm.html
Approximate Tubing lengths:
5/8" Tubing: 2-2.5'
1/2" Tubing: 1.5-2.5'
# of 90 degree turns:
3/4" Schedule40 Pipe: 4 (on each side of quick disconnects)
T's:
1/2" Copper T's: 2 (on inlet and outlet of radiators)
Y's:
1/2" Hose adapter Y (after CPU block)
Anyone care to estimate the Head that will give me, and the resultant expected flow with the pump I have chosen?