[BrianW]

In my next case I will be using the Iwaki MD-20RZ(T) ( http://www.iwakipumps.com/pub/SpecSheets/MD1520.pdf ).

Here is a thread pertaining to my setup: http://forums.procooling.com/vbb/sho...&threadid=5543

Q1:

I noticed on a few pics that the piece that houses the inlet anf oulet portions of the pump is one piece and that it is attached to the pump with six bolts. In the picture below you will see how I plan to rotate that piece 60 degrees ( rotate one bolt ). First of all I would like to know if this is even possible? Anyone with them that have taken them apart, would it be possible tro rotate that last piece 60 degrees to the right? If possible, would it impede flow or pressure at all?




Q2:

I am interested in buying this pump : Iwaki MD 20RLZT 100 volt water pump, high pressure rated from this retailer : http://www.deepseagallery.com/iwaki_pumps_and_parts.htm .Is this the same pump as the MD20-RZ(T) listed here: http://www.iwakipumps.com/pub/SpecSheets/MD1520.pdf ?

Thanks,

Brian W