Pro/Forums - View Single Post

Balinju · 02-18-2003, 12:31 PM

I need to ask a question here, what do you think will be the best to place in the middle, a cylindrical shaped pin or a cone shaped pin. I updated my cad drawing and instead of putting the cylindrical pin, I inserted a cone shaped one but 2mm shorter in height than all the other fins.

Can you give me a suggestion and tell me what is the best between the two, if they are needed, i can post new jpg images with the pin in the middle, or if needed i can also give you the .dwg or .dfx so that you can see it more clearly.

Any advice before it goes to milling??

02-18-2003, 12:31 PM	#87
Balinju Cooling Savant Join Date: Dec 2002 Location: Malta Posts: 495	Adivce before milling I need to ask a question here, what do you think will be the best to place in the middle, a cylindrical shaped pin or a cone shaped pin. I updated my cad drawing and instead of putting the cylindrical pin, I inserted a cone shaped one but 2mm shorter in height than all the other fins. Can you give me a suggestion and tell me what is the best between the two, if they are needed, i can post new jpg images with the pin in the middle, or if needed i can also give you the .dwg or .dfx so that you can see it more clearly. Any advice before it goes to milling??