Pro/Forums - View Single Post

#Rotor · 02-20-2003, 08:23 PM

I use AutoCAD 2000

punch... as in use a sharp nail or preferably a punch, and a hammer(NO Not the CPU)

, then gently punch an small indentation into the copper, exactly where you want the center of each hole to be. This will prevent the bit from drifting off target, while you drill...

once all the holes are punched it's as easy as this

the end resault should look something like this.....

02-20-2003, 08:23 PM	#5
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	I use AutoCAD 2000 punch... as in use a sharp nail or preferably a punch, and a hammer(NO Not the CPU) , then gently punch an small indentation into the copper, exactly where you want the center of each hole to be. This will prevent the bit from drifting off target, while you drill... once all the holes are punched it's as easy as this the end resault should look something like this..... __________________ There is no Spoon....