No cutting required, and I know it would need a big pump, but then I wouldn't be aiming for high flow rates with this one. I'm trying to design a block that would work efficiently with not to high a flow rate, so other blocks in the loop don't become such a limiting factor.
I haven't finalised the design yet and I'm not exactly sure if it will work. However, due to me having finals this summer, it's gonna have to wait until then.
As a side note, I might be tempted to go for 0.45mm channels and fins, or maybe 0.45mm channels and 0.35mm fins. Will try out different designs.
8-ball
|