Pro/Forums - View Single Post

#Rotor · 02-23-2003, 01:52 PM

jip.... each hole connects to the 4 holes around it with a thin slot, cut with a dremmel... so as to create the pins and allow the fluid to get through the block.... actually very simple, the idea, but it works like a charm..... the formed pins are "concave-square" with is absolutely ideal for heat-transfer from copper into water, as it maximizes the ratio between the pins surface & volume. not to mention the increased turbulence as a result of the sharper than 90º corners of the pin....

02-23-2003, 01:52 PM	#25
#Rotor Cooling Savant Join Date: Feb 2002 Location: Dione, sector 4s1256 Posts: 852	jip.... each hole connects to the 4 holes around it with a thin slot, cut with a dremmel... so as to create the pins and allow the fluid to get through the block.... actually very simple, the idea, but it works like a charm..... the formed pins are "concave-square" with is absolutely ideal for heat-transfer from copper into water, as it maximizes the ratio between the pins surface & volume. not to mention the increased turbulence as a result of the sharper than 90º corners of the pin.... __________________ There is no Spoon.... Last edited by #Rotor; 02-23-2003 at 04:29 PM.