Quote:
Originally posted by Smiley
yes they where cast from ductile iron but with the amount i use them they keep cracking
so i thought i would get some made outa tool steel i have a 800 pound tool steel anvil i cut and made and its great :-) but i just dont have a mill / Lathe to do this
wouldnt the bowls be milled ?
thanks thoe
|
I think the bowls couldbe. At least the outer part. If the inner part is a must to have bowl shapped then a lathe would probably be needed. Might take both. Going to take a good mill to do that kind of steel. I don't think anyone on these forums has that kind of equipment. Could be wrong though.