Weak clip? So what if it was designed for heatsinks... hell overclocks use old heatsinks to make water blocks (I'm making one now). And I did a lot of installing with waterblock not moving even a bit. You don't need so much pressure, just make sure you put the moving part at bottom then slightly push on top till it goes on, if it's too short means you didn't stretch elbows far enough. It's very simple because the clip is simple but it holds things very tight, if you have cold plate and peltier just stretch elbows more this will also stretch the whole thing so you reach the plastic thingies.
Just try it if you have FCPGA it's sooo awesome. I'm going to get a digital camera in 20 mins and make pics. BRB
|