[g.l.amour]

this is the same thing rotor asks. his block has been copied a mighty lot, yet noone has started to make a living from it.

result, lots of ppl feel very happy and honoured that an inventer of a method is helping them fabricate something; with good advice and tips. one can be proud of accomplishing something. in the mean time i hope some of the coppycats can give something worthwile back. if someone finds something that further refines a method, the community can learn.

i will never forget to mention who has been the inspiror of a certain block. believe it or not, this block was designed to use some of cathars ideas ;-) it's as close as rotor's method would come to cathar's. i'm sure if i could make a nozzle at the barb inlet that the block would be about as good performing as a drill press block can get. but now the water is prolly not jetted against the base.