Pro/Forums - View Single Post

Blackeagle · 02-26-2003, 05:03 PM

Bobkoure,

You're right, the one I'd make form that sites materials isn't real low cost. I forgot that part of his request.

But round stock while a bit harder to work with, isn't all that much of a issue. Or cut a semicircle out of flat stock and weld it on the side of the tube for that matter, would take a couple layers though.

While it is more expensive, it's also more sharp looking as well.

02-26-2003, 05:03 PM	#21
Blackeagle Thermophile Join Date: Oct 2002 Location: U.S.A = Michigan Posts: 1,243	Bobkoure, You're right, the one I'd make form that sites materials isn't real low cost. I forgot that part of his request. But round stock while a bit harder to work with, isn't all that much of a issue. Or cut a semicircle out of flat stock and weld it on the side of the tube for that matter, would take a couple layers though. While it is more expensive, it's also more sharp looking as well.