Quote:
Originally posted by Balinju
#rotor, i have another question for you before you kill me, how the h*ll do you make the o ring cut in the block using only a drill press??
and secondly, how deep are the cuts made with the dremmel??
thank you 
|
indeed, I do not use oring, I use marine Goop, and I make sure the two mating surfaces are absolutely free of grit, dirt or oiliness, then just with an evenly smeared coating of goop, over the complete mating surface, ( only one side) I bolt the two plates together, and let dry.... in the 3 years I've been doing it like this.... not a single leak from one of my blocks....
Wannabe
Here is a screenshot of the design... I gave you the dimensions of the block, so you should have no problems in scaling to fit.... the holes are for 0,125t (1/8") drill-bits, but you need to be very accurate, the tolerance is less than 0.04mm
have fun.
only one request from you, and any others, that might find enlightenment.... you gota come post some pictures of your artwork....That is All I ask in return... Post em here, or send them to me for my online Gallery, no matter...