Quote:
Originally posted by iroc409
res-->pump-->chiller(cold)-->cpu-->chiller(hot)-->rad-->res
|
I tried that - didn't work...
Using two 172 watt Pelts sandwiched between two Maze 2 waterblocks an E-1250, two BIE in parallel and a Maze3 on CPU. The water actually got much hotter with the Pelt "chiller" than running without it. Proved a valuable lesson to me though. It really drove home the point that Pelts consume 3 to 4 times the power that they pump! So with two Pelts, each dumping 180 watts of waste heat into the water plus about 70 watts from the CPU - way more than two relatively small rads could handle => so the water temp went up instead of down.
You have to go with two seperate loops: hotside and coldside...
