Pro/Forums - View Single Post

ColdFlare · 03-02-2003, 11:25 PM

I have two panaflo l1as on my heatercore the one from dangerden setup in a 1040 antec case. I havent cut a blowhole in the front yet, but i have the heatercore sitting ont he bottom right under the hard drive rack. The fan pushing in does not have a shroud and the one pulling does.

When i put my hand on the outside of my case i feel very faint air moving in, but when i put my hand in the case right next to the pulling fan, i feel nothing. The air isnt going through the heatercore and my temps are high.

Are these temps normal, kx7333 sensor untouched, t-bred b 1700+ @ 2.3ghz 2.0v
53c load
45c idle
Case temp is 37c, maybe cause by the heat coming from the pump which is right next to the sensor.

The heatercore is warm to the touch.

Do I need stronger fans? or a 2nd shroud? or cut a complete 120mm blowhole in the front?

03-02-2003, 11:25 PM	#1
ColdFlare Cooling Neophyte Join Date: May 2002 Location: New York City Posts: 42	Fan pressure not enough I have two panaflo l1as on my heatercore the one from dangerden setup in a 1040 antec case. I havent cut a blowhole in the front yet, but i have the heatercore sitting ont he bottom right under the hard drive rack. The fan pushing in does not have a shroud and the one pulling does. When i put my hand on the outside of my case i feel very faint air moving in, but when i put my hand in the case right next to the pulling fan, i feel nothing. The air isnt going through the heatercore and my temps are high. Are these temps normal, kx7333 sensor untouched, t-bred b 1700+ @ 2.3ghz 2.0v 53c load 45c idle Case temp is 37c, maybe cause by the heat coming from the pump which is right next to the sensor. The heatercore is warm to the touch. Do I need stronger fans? or a 2nd shroud? or cut a complete 120mm blowhole in the front?