Quote:
Originally posted by msv
Hello!
Theoretically (since I´ve drilled any WB:s) it looks as if the incoming waterflow up from the pinpattern is blocking the way for the incoming water.
If the pinpattern, as Jaydee116 states, continued over to the WB outlet You would get a better waterflow through the block, and (hopefully) lower temps.
The design in itself looks promising.
BTW: How wide are the channels You´ve cut between the holes? How did You cut them?
I´m a bit fascinated by large, metalcutting devices, and want to justify a purchase of one by drilling WB:s.
regards
Mikael S.
|
Well i just used a screw driver to get out the bits in between the "pins" because there was only like 0.2mm after the holes were drilled. I think i drill my holews much closer together than rotor or similar, like my holes practically (and sometimes do) join so i ahve to do very little cutting to open it up. Understand? its kindof hard to explain.