Well, if you have access to cnc, I would say make you a nice block and just replace the pump in your system....Should get a hefty boost in cooling just getting rid of that ridiculous excuse of a block.
Koolance, at its introduction, was a very nice performing system,components, ect. But has went to $hit in the recent year or so.
I wouldnt even waste any time trying to make a good performing system out of existing Koolance components, and just rebuild a system from the ground up.
Whatever you decide to do, good luck!
A side note......once you start making blocks with that cnc, you will be hooked.....believe me!
|