Pro/Forums - View Single Post

BillA · 03-06-2003, 03:12 PM

Ben
you do not know what you are talking about
the image you have posted above is indeed for a nozzle
where 'nozzle' is defined as the fitting used for a penetration by a small cylinder into a larger one
- as in a pipe into the sidewall of a tank
-> and it was suggested BEFORE that you look up the definition of an 'ASME nozzle'

see those angles on the small end ?
any idea what they are about ?
try welding

yes, the radius of curvature is intended to minimize the flow impediment, but so what ?
where is the flow into a wb going from a flat surface normal to the direction of inlet flow ?

arrghh, what are you 'covering the topic' with ?

CheeseBall
make a smooth taper, 3 or 4:1 is fine

EDIT: added avatar just for Dave
(lots of masochism apparent in these froums)

03-06-2003, 03:12 PM	#14
BillA CoolingWorks Tech Guy Formerly "Unregistered" Join Date: Dec 2000 Location: Posts: 2,371.493,106 Posts: 4,440	Ben you do not know what you are talking about the image you have posted above is indeed for a nozzle where 'nozzle' is defined as the fitting used for a penetration by a small cylinder into a larger one - as in a pipe into the sidewall of a tank -> and it was suggested BEFORE that you look up the definition of an 'ASME nozzle' see those angles on the small end ? any idea what they are about ? try welding yes, the radius of curvature is intended to minimize the flow impediment, but so what ? where is the flow into a wb going from a flat surface normal to the direction of inlet flow ? arrghh, what are you 'covering the topic' with ? CheeseBall make a smooth taper, 3 or 4:1 is fine EDIT: added avatar just for Dave (lots of masochism apparent in these froums) Last edited by BillA; 03-06-2003 at 03:22 PM.