[Volenti]

Originally posted by MadDogMe
Have you still got that 1U thermaltake skived P4 HSF Volenti?, would make a good blank to start from, I'm sure the potential in them is huge for home DIY blocks , I remember 'Badams' BillA sayins so, so it can't be bad(ams ) , "just take a 1U TT HSF and cross cut to your fancy" was the quote...

I've been wondering about 'fins ~V~ pins' ever since, you've answered my query! . Time to get the junior hacksaw out! ...

That project went from this;



to this;



then finally to this;




That final version has a ~2mm BP, 5mm high fins and the same 20mmx20mm fin area as the second inside pic shows, it's only ~2 degrees off my micropin block on my T-bred 2100+@2.34, 1.85v.