Quote:
Originally posted by the creature
Doesen't you just put water in the air-trap to fil it and then the air-trap does the draining part?
|
For filling of the system see next picture...
Close lid of airtrap firmly, close big valve, open 2 little valves, suck on tube on upper valve until pump is filled with liquid, start pump, let circulate a few minutes, open big valve, close 2 little valves, and circuit is filled and almost bleeded...(+ disconnect 2 filling tubes)
To drain: Stop pump, open airtrap, open lowest valve and let liquid drain in a recipient (to empty system)...
Easy...
I use the the airtrap only to fill with cooling liquid when level goes too low...
CD
