i would appricate any comments / tips you guys might have on this wb i made from the base of the akasa ak360 copper cooler.
would removing even more of the fins on the outer edges at and at the same time making the inside of the top smaller improve performance ?
i also think if the initial copper cooler didnt have the gap in the center that would improve the wb but i dont have the ability / tools to make my own copper base plate with the micro fins.
i have tested it and the setup worked very well. I have a 900l/h pump. heater core almost the same as the chevvy running on a p42.4
room temp 17.9C
cpu 19C
water 18.3C
m/b 19C
after 1 hour
room temp 18.3C
cpu 21C
water 20.2C
m/b 26C
i ran sandra cpu test 60 times
room temp 18.3C
cpu 26C
water 22C
m/b 27C
after 5 mins back at idle
room temp 18.4C
cpu 21C
water 20.9C
m/b 26C
hope you guys can help
Lee