Pro/Forums - View Single Post - Polycarbonate Tops... a scientiffic analysis!

OTMOPO3OK · 03-12-2003, 01:14 PM

MadDogMe,
i'm with you 100% on this one...
i hate barbs...
first of all they cost like 1.5$ each then u have to make a tread (which is PITA since the diameter is big) and after all that they have such a small ID....i use copper tubing all the way...cheap and the ID is almost the same as OD cos the walls are very thin....
just solder and off u go...

and yes 99% of ppl use them.....:shrug: hmm...ppl are not thinking themselves they just see a design and blindly follow it....

sorry to get away from the topic....needed to express on this one....

03-12-2003, 01:14 PM	#5
OTMOPO3OK Cooling Neophyte Join Date: May 2002 Location: Brooklyn, NY Posts: 45	MadDogMe, i'm with you 100% on this one... i hate barbs... first of all they cost like 1.5$ each then u have to make a tread (which is PITA since the diameter is big) and after all that they have such a small ID....i use copper tubing all the way...cheap and the ID is almost the same as OD cos the walls are very thin.... just solder and off u go... and yes 99% of ppl use them.....:shrug: hmm...ppl are not thinking themselves they just see a design and blindly follow it.... sorry to get away from the topic....needed to express on this one.... __________________ Keyboard not found. Press F1 to continue...