Pro/Forums - View Single Post

nexxo · 03-12-2003, 02:22 PM

There's other ways: you can use 3mm (M3) screwthreaded rods, as illustrated below (pic courtesy of Overclex.net). Just feed them through carefully...

I have found another way, but it is a bit hard to explain, and I can't be bothered to make complex drawings right now. Suffice to say that it involves hooking the edges of a shroud behind the lips that the mounting holes are drilled in, and wedging a securing strip over it... If that makes any sense.... :shrug:

03-12-2003, 02:22 PM	#7
nexxo Cooling Savant Join Date: Jul 2002 Location: Brimingham, UK Posts: 385	There's other ways: you can use 3mm (M3) screwthreaded rods, as illustrated below (pic courtesy of Overclex.net). Just feed them through carefully... I have found another way, but it is a bit hard to explain, and I can't be bothered to make complex drawings right now. Suffice to say that it involves hooking the edges of a shroud behind the lips that the mounting holes are drilled in, and wedging a securing strip over it... If that makes any sense.... :shrug: __________________ "There is a thin line between magic and madness"