Pro/Forums - View Single Post

leejsmith · 03-13-2003, 08:38 AM

yes that looks perfect.

just out of interest how would you make a top ?

i dont have any way to make a copper top so i used acrylic but the more i read on this subject the more reasons i find not to use acrylic .

I have a p4 so if i cut the fins down to be a little bigger than the p4 heat spreader and about 4mm in height that should be ok.

03-13-2003, 08:38 AM	#10
leejsmith Cooling Savant Join Date: Mar 2003 Location: notts uk Posts: 408	yes that looks perfect. just out of interest how would you make a top ? i dont have any way to make a copper top so i used acrylic but the more i read on this subject the more reasons i find not to use acrylic . I have a p4 so if i cut the fins down to be a little bigger than the p4 heat spreader and about 4mm in height that should be ok.