Well I’m fairly confident that if I place my suction point at one end of the cylinder and the input of the nitrogen on the opposite side and allow the nitrogen to purge the system I’m confident that I can get most of the humidity out. The other thing is that if I use a phase change system due to the fact that I’m not placing the evaporator unit Directly onto the heat source eg. CPU then most of the condensation if any will collect onto the Evaporator Radiator unit and not so much frost up on my mother board right? Then I can make a simple Drip tray or something along that line.
I think the desiccant might need a few hours to collect the unwanted moister once the Nitrogen environment is filled. But time is something I have lots of. Kinda
|