Pro/Forums - View Single Post

Rastlin · 03-20-2003, 07:43 AM

I had designed the block for cross cutting, and that was actualy one of my planed revisions winewood, though I think i will keep the gap between the center and the outlets, I was going to run the inlets right into the center forest of pins, in my next drawing.

03-20-2003, 07:43 AM	#22
Rastlin Cooling Neophyte Join Date: Mar 2003 Location: Michigan Posts: 22	I had designed the block for cross cutting, and that was actualy one of my planed revisions winewood, though I think i will keep the gap between the center and the outlets, I was going to run the inlets right into the center forest of pins, in my next drawing.