[LiquidRulez]

Originally posted by Tuff
May I throw this variable into the equation...if you have a 1/8 inch hole and wish to increase the pressure but have the same amount of water flow.

Would you not oblong the hole???

In other words...stretch the hole out sideways...maintaining the same size opening...just a different shape.

This type of Nozzle is used for carpet cleaning so that a relatively close pressure and water flow is produced across the entire range. Not much variance from the middle to the sides

If you have 150psi in the middle you will have a slight drop at the sides.

From what I understand...the cpu runs hotter in different sections...so by using an oblong hole would you not have a better chance at supplying pressure and more flow of the water water to all the parts that need it?


Another example the spray wand at the carwash. This is done with an oblong hole. Some of these nozzles supply 1000-1500psi.

Tuff

:shrug: