Quote:
Originally posted by JFettig
I beleve the reason he may have broken end mills was taking too large of passes? too low of rpms? lack of use of lube?(doubt that, from that pic)
|
The real reason is that he was in a hurry because he had other jobs to do
He cut quite deep perforations each time, about 1.5mm each time i think
btw it is performing very well
the maximum load temperature was 36/37 degrees according to asus probe, but you have to remember that a heat load more than 1 kw was being simulated in the loop
cooling with 4 very tall bongs
with this block we managed to overclock the amd xp 1700+ tbred B 2200mhz (12.5*176)