Copied from an old posting from PH:
If you have the complete Innovatek setup, I would (humbly) suggest to just leave it as is. They have some pretty good engineers dealing with wc systems in Germany.
If you decide to repace with normal barbs, you probably can just use a normal 1/4" NPT x 1/2" barb and torque it into place. The BSP fittings are slightly different, but not too much. It just takes a bit of muscle...
This is what I did and it works great, use only the straight fittings though the 45 degree fittings will interfere with the clamp that holds the block to the MB and the 90's wont go at all.
Aardil
|