Pro/Forums - View Single Post

hara · 03-26-2003, 03:48 PM

Adding to an already proven concept is very good.

IMO, the design involves the tooling required to cut a WW block. This means that to be able to do this block, one has to be able to do a white water. 7 channels (13mm), are too little. I would Increase it to about 18mm.

Also, starting with aluminium is a good decision as you will waste a lot of metal perfecting the machining methods. Just a constructive suggestion.

03-26-2003, 03:48 PM	#14
hara Cooling Savant Join Date: Oct 2002 Location: Malta, Mediterranean Posts: 662	Adding to an already proven concept is very good. IMO, the design involves the tooling required to cut a WW block. This means that to be able to do this block, one has to be able to do a white water. 7 channels (13mm), are too little. I would Increase it to about 18mm. Also, starting with aluminium is a good decision as you will waste a lot of metal perfecting the machining methods. Just a constructive suggestion. __________________ - Every great HD crash day is the day before back-up day. - My Past System - "Better to reign in Hell than serve in Heaven." - Milton, Paradise Lost. - FMZ