Quote:
Originally posted by max
well i basically just made this here
http://forums.procooling.com/vbb/sho...6&pagenumber=2
near the end.
Its hard to see whats inside there but it looks like the attached pic.
In my test it didn't perform better than my other blocks but no worse, maybe I have hit a wall?
|
you had no jet effect happening, hence the "average" performance.
advice for GTA;
focus on an even smaller area above the core, 20mmx20mm max, drill the holes to at least 1mm off the bottom of the BP, use jet holes 1.5mm to 2mm in dia, remove any pins in the flow path that aren't in the designated jet area.