ok so here it is. i changed the way water is going to enter the block. i don't know if there is a name for this but here is the concept. in the block there are 7x7 holes of 2mm each, in the second layer there are 5x5 holes 1.5mm each. the top layer will be smaller in height that the thread of the barb so that the thread of the barb enters in the hole that there is in the second layer round the holes.
there are 2 x 3/8" outlets and 1 x 1/2" inlet. hope that you understand the diagram. btw i am planning that both the second layer and the top will be made out of perspex
__________________
So the bullet proof vest aint a $hit when d laser is pointed to your head Kid
|