Quote:
Originally posted by unregistered
but I suspect you do not understand just how small is the internal ID in the swivel section
have you actually measured it ? what is the ID ?
you made a statement, I am asking for the numbers on which your statement was based
(I have, its in the article eh ?)
|
The angled fittings, as supplied (by the manufacturer) with the blocks have an internal diameter in the swivel section of approximately 4.28mm by my measurements.
The straight ones are closer to 5mm
The angled fitting I have on my own block, by comparison, is 5.5mm.
I'm not sure what conclusion you think I'm trying to draw here apart from the fact that these connectors can serve a purpose if you choose to use them for efficient hose routing.
Oh and I subsequently received an apology from the forum member you cite.