Quote:
Originally posted by bigben2k
That's been puzzling me, ever since you posted it:
What is it?
|
hi ben,
i was playing with an idea that could point a jet to each indent in a base plate. I think volenti's idea worked better. The channels cut into the acrylic would be to restrictive.
how is the project going you have generated some good ideas in this thread. Has cather had a base milled yet ?
are you still working on a plastic top ? i found you can make the sides of the top where you cut it look clear if you quickly lap it down to 1500 grit then coat it with clear spary.