Quote:
Originally posted by hara
Update:
I found a way to modify the drill press so that I can adjust the height z axis with a bolt. I bought a shitty (pun intended) xy table and a 5mm 4 flute endmill. I am using a 5mm endmill because i'm milling 2.5mm at a time. This is what I did:
|
when i did that, muhaha, that's the result i got.
At least on my drill press, that's not a good method to use. i got a crappy result using that method when i tried, so i had to find a much much more accurate way. If i only had a digital camera!!!