hey i was reading a recent thread and in it person discussed cooling the water by having the water flow through thin, flat channels.... I was wondering if anyone had experience doing this, and is so
--what thickness copper plating did you use?,
--what are the optimal dimensions to use for a good balance between waterflow and cooling capacity?
--What is the performance you are getting out of this?
--How is your perfmance compared to a heatercore such as the chevette heatercore than many use?
I'm about to be ordering a bunch of metal to make my new block with dremel + dremel drill press+ cross slide vise
and since onlinemetals.com shipping is kinda high, i would like to get this all in one order... thx much guys
1st post!! haha