Quote:
First it was "it will never work because of blah blah blah..." and now it's "it's not working as well as you think because of blah blah blah..."
|
Who said it'd never work?. I've seen no~one 'diss' your block, on the contrary everyone likes it,
but sees improvments...
Did you come here for feedback on your block or to get your ass kissed?, ocers.com is probably your best choice for the later so I hope you came for feedback?...
_________________________________________
IMO those pads are'nt worth shit for core protection BB, It's the 4holes mounting that provides stability. A good even pressure on each corner is where it's at (by good I mean 25lbs+). A 'centre' mounting may allow it to 'tilt' under adverse loads on the tubes or block and crush the core, but saying that it should'nt ever happen under normal curcumstances should it?, you'd have to
grab hold of the tubes and yank on them...
I'd use silicon tube so there's no extra torque on the block though, my old SK6 spring clip was crap, I had to bend it tighter myself cause the weight of the block used to 'loosen' it up after being on there a while, and PVC tube does have a stubborn 'memory'

...